Rain Control
Almost all of the small general
aviation aircraft use transparent acrylic plastic windshields, and this soft
material is so easy to scratch that windshield wipers are seldom installed. One
way to minimize the effect rain has on visibility in flight is to keep the
windshield waxed so water will not be able to spread out over the surface, but
will bead up so the propeller slip stream or wind can blow it away.
Larger and faster aircraft that routinely operate in rain
have rather elaborate rain control systems. There are three methods used to control
the effects of rain and they may be used together. These three methods will be
discussed separately. They are mechanical windshield wipers, chemical rain
repellant, and a pneumatic rain removal systems.
Measures: There are different methods that may be found on
aircraft as a measure of protection
against the problem due to rain on windshield:
Pneumatic Rain Removal: High-pressure bleed air from the
engine is blown over the face of the windscreen from ducts mounted at the base
of the screen. The air blast forms a barrier that prevents the rain spots from
striking the screen.
Wind Screen Washing System: A windscreen washing system allows a
spray of fluid (usually de-icing fluid e.g. kill frost), to be directed on to
be directed on to the windscreens to enable the windscreen wiper to clear dust
and dirt from dry windscreens in flight.
The
fluid is contained in a reservoir and sprayed on to the screen through nozzles.
The fluid may be directed to the nozzles by an electrically driven pump or by
pressurizing the top of the reservoir with compressor bleed air via a
pressure-reducing valve.
Rain repellant system: When water is poured over clear
glass it spreads evenly to form a thin film. Even when the glass is tilted at
an angle and subjected to an air-stream, the glass will remain wetted and
reduce vision. However, when the glass is treated with certain chemicals
(typically silicone based), the water film will break up and form beads of
water, leaving the glass dry between the beads. The water can now be readily
removed. The principle is used on some aircraft for removing rain from
windscreens. The chemical is stored in pressurized, disposable cans and is
discharged on to the windscreen through propelling nozzles.
Some of
these measures are described in subsequent sections.
No comments:
Post a Comment